RK11 and M9312 questions

From: William King <wrking_at_tsoft.com>
Date: Wed Aug 25 10:40:48 1999

I just received a load of boards that were associated with an 11/34. I'm
going to try to upgrade my 11/04, but since I don't have any doc's I have a
few questions. If anyone could help, it would be greatly appreciated.

1. What are the switch settings for a M9312 bootstrap/terminator card?

2. On the M9312, there is a jumper that has been lifted on the left edge of
the card (next to the third chip up from the edge connector). What's this
for?

3. My M9312 has three empty sockets. Is this normal?

4. I have a 4 board set for the RK11 controller. Can this plug into a
standard unibus, or does it require a special backplane? If I remember
correctly, you use a unibus extension cable to daisy chain into the rk05's.

5. Can anyone direct me to the description of the two edge connectors on the
top of the 11/34 board set?

Thanks,

Bill
Received on Wed Aug 25 1999 - 10:40:48 BST