On Dec 3, 20:19, Joe wrote:
> >I have a spool (1 lb?) sitting behind me of 96 SN silver solder, wasn't
> >"too" expensive and melts with a slightly hotter tip in my weller.
>
> That's the same kind of stuff that they sell here for soldering copper
> water pipes. NO LEAD ALLOWED! The last time I checked it costs about
> $16/pound. That's cheaper than good electrical solder.
Same here, at least for new installations. There are regulations about the
flux, too, I beleive.
> You have to watch out for any solder and make sure it's for electrical
> work. There are many other kinds of solder and many (most?) of them have
> acid fluxs. You can use it on electrical stuff but you'll be replacing
> everything in about six months!
Yes, most fluxes apart from rosin are at least mildly acidic, including
some electrical types -- you just have to ensure you wash them off properly
(and soon).
> That's an interesting idea. But I certain that you'd have to heat the
> joint to the melting pont of the old solder before this stuff would alloy
> with it. If that's the case then you could just take the part off then
and
> not go through all the rest of the procedure. I've mixed various lead
> alloys for casting bullets and you have to heat the mix to the melting
> point of the element with the highest melting point before they will all
> melt and alloy together. This is true even if the alloy has a lower MP
than
> the individual elements.
Curiously, that's not always the case, especially if you consider surface
effects. Solder actually sticks to a metal surface by forming a very thin
layer of an alloy with it. In effect, the solder dissolves the other metal
very slightly. That's partly why a copper soldering iron bit gradually
wears away even if you keep it well tinned, and partly why thin plain
copper cable that has tinned ends is weakest just at the point where the
tinning ends (the solder leaches away a tiny amount of copper, leaving the
wire slightly thinner just at the junction).
--
Pete Peter Turnbull
Dept. of Computer Science
University of York
Received on Fri Dec 03 1999 - 19:34:20 GMT