I've got the EXT-4000-series manual. I never owned one of the 4380's,
though I tested a number. Miniscribe built a model 9380 which was quite
similar, except that fewer than 10% of them would pass our tests. However,
I used the 9380's for quite a while in my personal systems.
There was once a military (air force, I believe) site called TheRef, which
had much of this data, if you haven't the patience for me to look up the
information you need. I recall there were quite a number of jumper
options. If you can find me the desired configuration, I can give you the
relevant jumpers and their effects.
Dick
----------
> From: Zane H. Healy <healyzh_at_aracnet.com>
> To: Discussion re-collecting of classic computers
<classiccmp_at_u.washington.edu>
> Subject: Maxtor XT-4380E ESDI Hard Drive settings
> Date: Sunday, February 28, 1999 5:19 PM
>
> OK, I'm stumped. I'm finally getting around to adding one of the 380Mb
> ESDI HD's that I got to replace the 150Mb ones I've been using in my
> PDP-11/73. So I check out "The Tech Page" and while they've got the
drive,
> they don't give any of the jumper settings. Does anyone happen to have
the
> settings for this drive?
>
> Zane
> | Zane H. Healy | UNIX Systems Adminstrator |
> | healyzh_at_aracnet.com (primary) | Linux Enthusiast |
> | healyzh_at_holonet.net (alternate) | Classic Computer Collector |
> +----------------------------------+----------------------------+
> | Empire of the Petal Throne and Traveller Role Playing, |
> | and Zane's Computer Museum. |
> | http://www.dragonfire.net/~healyzh/ |
Received on Sun Feb 28 1999 - 18:22:26 GMT