>On Sun, 4 Jul 1999, Richard Erlacher wrote:
>>If I were using the DIN connectors, I'd get a standard out, read and
>>understand it, and then use it, calling it VME, its rightful name.
>>Unfortunately, I'd not be able to get a two-port serial board or a LAN board
>>for VME from the local thrift store.
>I don't get it...are you saying that the connector somehow determines the
>bus? An bus could in theory be compatible with ISA and use some other
>connector, and still be ISA for the most part.
I suspect that it's just Dick on one of his rants these days. VME
boards are extremely plentiful these days, as are prototyping boards
with the connectors.
Of course, there are cases where the same connector was used on two
different busses. The connector and card size of the Motorola EXORcisor
system is remarkably similar to the S-100 bus (to the point where I've
actually mistaken one for the other until I got up close and looked.)
And the 44-conductor-edge-connector design has been used in so many
instruments and machines that it is completely "generic".
There are *many* ISA-compatible busses in use in the embedded systems
world that use "different" connectors. Some of these are proprietary,
meaning they're only used by one company, others are much more widespread
(like the PC/104 bus). OK, there are some drive differenences between
PC/104 and ISA, but that's an "improvement" for the application. See
http://www.pc104.com/ for a PC/104 FAQ. PC/104 was originated by Ampro,
a maker of classic computers, so I feel justified in mentioning it here :-).
--
Tim Shoppa Email: shoppa_at_trailing-edge.com
Trailing Edge Technology WWW: http://www.trailing-edge.com/
7328 Bradley Blvd Voice: 301-767-5917
Bethesda, MD, USA 20817 Fax: 301-767-5927
Received on Mon Jul 05 1999 - 08:37:04 BST