Say, while I'm wasting everyone's time, where might I obtain a boot
disk for my HP 150? Would any version of Dos 2.1 work or do I need
an HP version. And many thanks all. This really is a swell bunch of
people you have here!!
-----Original Message-----
From: CLASSICCMP-owner_at_u.washington.edu
[mailto:CLASSICCMP-owner_at_u.washington.edu]On Behalf Of
jeff.kaneko_at_juno.com
Sent: Thursday, July 29, 1999 10:38 PM
To: Discussion re-collecting of classic computers
Subject: GPIB,'C' and the HP-150 (was:Re: Tek 4041)
On Thu, 29 Jul 1999 21:51:04 Joe <rigdonj_at_intellistar.net> writes:
>Tony,
>
>At 11:16 PM 7/29/99 +0100, you wrote:
>>> , but
>>> >doesn't the HP150 have an IEEE-488 port (aka GPIB, HPIB) as
>>> >standard.
>>>
>>> Yes, it does but the 150 uses the port to connect to
peripherals
>>> operating under MS-DOS. It has no commands that will let you
send or
>>> recieve specific strings over the HP-IB.
>>
>>That's news to me (and I guess to HP). The HP150 Technical
Reference
>>Manual has a section entitled 'HPIB Interfacing' which describes
how to
>>use the HPIB port for non-disk devices.
>>
>
> THAT's news to me! I've never heard of using a 150 as a HP-IB
>controller and I have a large STACK of 150 documentation and none
of
>it even hints that you can what you're talking about. Can you
make a
>copy of that for me? S_at_#* and I've got a pile of 150s setting out
in
the
>rain cause I had no use for them!
Now see, I figured that you knew this, Joe. I remember when I was
working for motorola, they tried to market an automated radio test
system that used an HP-150 as an instrument controller, attached
(via GPIB) to a service monitor, and a *BIG* interface box called a
'barn' that routed the audio, PTT, etc.
It didn't sell. The application software sucked.
<SNIP>
> In C? Is there a C that will run on the 150? Most of the
software
>has to be tailored specificly for the 150 or else be VERY MS-DOS
>compatible with no short cuts. I've heard of BASIC, Assembler and
Pascal
that
>will run on the 150 but I haven't heard of a C compiler that would.
I suspect any version of 'C' that is a straight command-line
c-compiler
*ought* to work (using dos calls only, of course). Hmmm. Turbo C
1.0
comes to mind. The hard part will be getting the HP-150
implementation
of dos 2.x (or better, 3.x).
Dang it Joe, see what you've done? Now I have to buy an HP-150 to
try
this out. S_at_#*. :^)
Jeff
___________________________________________________________________
Get the Internet just the way you want it.
Free software, free e-mail, and free Internet access for a month!
Try Juno Web:
http://dl.www.juno.com/dynoget/tagj.
Received on Thu Jul 29 1999 - 22:58:15 BST