Careful with that grease! Vaseline is likely to make some plastic alloys
soft, as it contains solvents for some of them. The clear grease most often
used in lubricating plastic gears, bushings, etc, is called "lithium grease"
and is available at most wholesale outlets which sell screws, nuts, bolts,
etc. by the box.
I have, by the way, found that a box of 100 of some of the more common
screws found in electronics is a really worthwhile investment and saves
money in the long run. This is especially true of metric sizes. Here in
Denver, it's the rule rather than the exception that hardware and car parts
stores sell both metric nuts and bolts, yet it's unusual to have bolts and
nuts of the same size as marked on the blister pack actually fit. I don't
know why this is, but it's a real pain in the gluteus maximus! I've never
had this result at Fasteners Inc. I guess that's why I'd rather buy the
small stuff by the box there rather than the handful at the hardware store.
Dick
-----Original Message-----
From: Tony Duell <ard_at_p850ug1.demon.co.uk>
To: Discussion re-collecting of classic computers
<classiccmp_at_u.washington.edu>
Date: Sunday, May 09, 1999 2:59 PM
Subject: Re: Teac FD-55GFR 5.25" floppy drive
>>
>> Hi,
>>
>> On Fri, 7 May 1999 Tony Duell wrote:
>> > Take off the spring. I believe that you can normally take the collet
>> > apart further, but this isn't in the manual. Apply a smear of grease
>> > (either plastic grease or vaseline) to the spindle and reassemble. Put
>> > the spring on with the smaller end against the collet.
>>
>> Tried doing that, and it didn't help. It turns out that the C-clip was
>> vibrating, causing the noise; I should probably have figured that out
sooner.
>> Putting some grease in the groove that the clip fits into solved the
problem. I
>
>The C-clip should be a tight fit on the spindle. If it can move relative
>to the spindle, then it's too loose. It might be worth taking it off and
>either replacing it or squeezing it slightly.
>
>> guess using a hot-melt glue gun would do the job too. (Maybe this info
will be
>
>I am strongly of the opinion that if something is assembled with glue
>then it was designed incorrectly :-). And I would certainly never put
>glue on something that I might want to take apart later.
>
>> of use to someone in future?)
>>
>>
>> -- Mark
>>
>>
>
>-tony
>
Received on Mon May 10 1999 - 09:53:17 BST