ST82500N: Need jumpers/switches

From: Michael Grigoni <msg_at_computerpro.com>
Date: Tue Dec 5 14:58:04 2000

Chuck McManis wrote:
> 1) Look for a set of three jumpers somewhere that have 'id' or
> 'addr' etched or silk screened near the board. If that doesn't work try
> adding a jumper (carefully) at each point and then probing the bus until
> the unit number changes.

No such luck with silk-screen labels, and the electronics contains
large numbers of switches and jumper headers, none of which are
obvious candidates for playing...


> 2) Read the code page and see if you can set the LUN to sometong
> other than 0

I like that idea and will try it, however it is still important to
learn how to setup and maintain the device.

It is a disk subsystem as contrasts a 'drive'; I will post a small
jpg of it perhaps later...

Michael Grigoni
Cybertheque Museum
Received on Tue Dec 05 2000 - 14:58:04 GMT