Soldering to PCB traces?

Contemporary messages sorted: [ by date ] [ by thread ] [ by subject ] [ by author ] [ by messages with attachments ]

From: Daniel A. Seagraves <DSEAGRAV_at_toad.xkl.com>
Date: Thu Feb 24 07:44:26 2000

I have here a perfectly good SCSI device I'd like to use, it's just that
the +12V pin in the power connector has broken off. Can I just solder another
pin right on the trace on the PCB, or is there some sealer over the traces?
(Or anything else I should know about?)
-------
Received on Thu Feb 24 2000 - 07:44:26 GMT

This message: [ Message body ]
Next message: Bruce Lane: "FW: MicroVAX II hardware available"
Previous message: Bruce Lane: "Mail servers changes (INFO)"
Next in thread: Bruce Lane: "Soldering to PCB traces?"
Reply: Bruce Lane: "Soldering to PCB traces?"
Reply: Marvin: "Soldering to PCB traces?"
Reply: Joe: "Soldering to PCB traces?"
Reply: Tony Duell: "Soldering to PCB traces?"

Contemporary messages sorted: [ by date ] [ by thread ] [ by subject ] [ by author ] [ by messages with attachments ]

This archive was generated by hypermail 2.3.0 : Fri Oct 10 2014 - 23:32:53 BST