"Ethan Dicks" wrote:
>
> --- Carlos Murillo-Sanchez <cem14_at_cornell.edu> wrote:
> > > > Does anybody know how to set the SCSI id for this bridge?
> > >
> > > Not without looking at a picture of the card.
> >
> > Here's a picture:
> >
> > http://huey.ee.cornell.edu/omti3100.jpg
>
> Try here - http://www.pc-disk.de/pcdisk/c/2000/1272.HTM
Thanks Ethan! Now, I've set the SCSI ID to 1. I also noticed
that the parity generation was disabled, so I enabled it.
However, when I connect the drive to another Mac, it locks
up the SCSI bus...
--
Carlos Murillo-Sanchez email: cem14_at_cornell.edu
428 Phillips Hall, Electrical Engineering Department
Cornell University, Ithaca, NY 14853
Received on Thu Oct 26 2000 - 11:09:00 BST
