Mobo Question

From: ajp166 <ajp166_at_bellatlantic.net>
Date: Sun Apr 1 12:53:19 2001

From: Richard Erlacher <edick_at_idcomm.com>


>I have a Packard Bell setup and an HP, both of which use an EISA bridge
>(according to the signon) and EISA-looking riser card, at right angles
in the
>case of the PB and parallel to the really small lower card in the HP.
Both have
>ISA expansion and PCI as well, and both have video, etc. (all the usual
mobo
>stuff) on the lower board.


Could be but since its a slim lince case even if it were EISA it would
have to
be shorter in height. Most of the boxen that require the 120 or so pin
card
do it for mechancical reasons and the busses can be ISA, EISA, and the
AT&T
I have has ISA, EISA and even PCI on the right angle card!

Allison


>
>Dick
>
>----- Original Message -----
>From: "ajp166" <ajp166_at_bellatlantic.net>
>To: <classiccmp_at_classiccmp.org>
>Sent: Saturday, March 31, 2001 10:22 PM
>Subject: Re: Mobo Question
>
>
>> From: Lanny Cox <chronic_at_nf.sympatico.ca>
>>
>>
>> >It's about 2 1/2 times bigger than a PCI slot, as i originally
>> mentioned. It
>> >looks a lot like an ISA port (ISA style connectors and black casing),
>> but is
>> >a lot bigger. There's only one connector on the mobo, which does
support
>> the
>> >riser card theory. Luckily, the system has onboard video, serial and
>> >parallel ports, etc. so it won't be so bad.
>>
>>
>> Thats the case. Most pizza boxen that are under 5" high have to mount
the
>> card
>> horizontally so the do the 120 pin connector and riser with the cards
>> plugging into
>> the riser sideways.
>>
>> I have a AT&T P100, Dell 486DX and Dell 386sx/16 all using risers
like
>> that.
>>
>> Allison
>>
>>
>
Received on Sun Apr 01 2001 - 12:53:19 BST

This archive was generated by hypermail 2.3.0 : Fri Oct 10 2014 - 23:33:23 BST