VERY LONG: Latest S-100 Haul
Hello all,
Thanks to a VERY generous man, located about an hour's drive from me, I have
a boatload of CompuPro S-100 stuff, 8" floppy drives, manuals, software,
etc. The list is long, and I debated posting it here, or linking to a web
page. In the end, I decided to post it here because I wanted it to be in
the archives in case anyone was looking for any of this stuff. I am more
than willing to copy floppies or manuals, no charge but postage (and you
supply the 8" media, as I am VERY short of blanks). The only caveat is that
it may take me a long time to do it, mainly becuase I'm not very organized
:-)
Before the list, there were also two Osborne 1 computers, one with a dead
internal monitor (but works from external monitor), and one fully
functional, with the double-density upgrade. Also, manuals and full sets of
original disks for each.
Without further ado, here's the list:
CompuPro chassis, 21-slot motherboard
- 1 Full CompuPro RAM22 board
- 1 Full CompuPro RAM22 board
- 1 Full CompuPro RAM21 board
- 1 Full CompuPro RAM16 board
- 1 Full CompuPro RAM17 board
- 1 Macrotech Dual Processor board -- 80286 and Z80H
- 1 CompuPro System Support 1
- 1 CompuPro DISK3 Hard Drive controller
- 1 CompuPro Interfacer 4
- 1 CompuPro DISK1A Floppy Drive Controller
CompuPro System 8/16 Chassis, 20-slot motherboard
- 1 Full CompuPro RAM22 board
- 1 CompuPro MDRIVE/H 512K/2 MEG disk emulator board
- 1 CompuPro CPU68K board
- 1 CompuPro System Support 1 board
- 1 CompuPro Interfacer 4 board
- 1 CompuPro DISK1 Floppy Controller Board
Three dual 8" drive units (one CompuPro, two no-name) -- The CompuPro unit
has two QumeTrak drives (242, I think -- full height 8"), one of the
no-names has two Shugart 801 drives (single-sided only, I think), and the
other no-name also has two QumeTrak drives. Unfortunately, the power supply
in the no-name QumeTrak drive box literally had an LM723CN explode, breaking
the chip in half, melting the socket, and fusing two pins to the socket.
Cheap enough for a new chip, but time to put in a new socket, and figure out
if something else has gone bad...
One dual 5.25" floppy and 5.25" 40MB hard drive unit
Additional S-100 cards:
- Mullen Computer Products bus tracer board
- CompuPro Interfacer 4 w/cable
- Solid State Music PB1 2708/2716 EPROM Programmer
- CompuPro DISK1 Floppy Controller
- Jade Double D Floppy Disk Controller
- Quantronics MM8 8K memory board, 64 2102 chips
- Performics 256KB RAM card
- CompuPro CPU-Z
- Jade JG-Z80 Rev. C CPU board (Z80A)
- Qty. 2 CompuPro CPU 8085/88
- Ackerman Digital Systems PROMBlaster II
- Franklin Electric I/O Interface
- Vector Electronics Interfacer II
- Jade Parallel Serial I/O Board
- Data Technology Corporation DTC 10-1
- Tarbell Cassette Interface, Rev. D Model 1001
- CompuPro System Support I
- CompuPro RAM17
- ExpandoRAM Rev. E
Original Software, 8" Floppies
- CompuPro CP/M 8-16, version 1.1R
- CompuPro CDOS 8-16, 4.1D-2, also labelled by CCT, version 2.0b
- CompuPro DR Net, version 1.1A
- CompuPro AMCALL/TIP Master, version 2.68/2.40
- CompuPro CP/M-80, version 2.2N
- CompuPro CP/M-80, version 2.2LD
- CompuPro CP/M-80, MDRIVE System Master, version 2.2LM
- CompuPro CP/M-86, version 1.1PA
- Jade CP/M version 2.2, for Double D controller card
- CP/M-68K, version 1.0, labelled by Westico Software Express
Service
- SuperSoft C compiler (no version, copyright 1981)
- CompuPro Assembler and tools 86 version 1.0
- CompuPro CP/M-68K version 1.1
- Digital Research C compiler for CP/M-86, version 1.11
- Term 3 by Echelon
- Z-COM by Echelon
- Discat by Echelon
- PKey and I/O Recorder by Echelon
- B/Printer by Echelon
20-30 Blank 8" media, some 1-sided, some 2-sided
Manuals (* = original, no * = photocopy)
- Code Works Small C for CP/M version n, April 1, 1981 *
- BDS C version 1.4
- Jade Double D Software Manual
- IMSAI 8080 Self-Contained System Operating System -- User manual
and source code listings
- Processor Technology Software Package #1 source listing
- Qty. 3 CompuPro Interfacer 4 * (w/ schematic)
- Digital Research CP/M 2 docs *
- BDS C Version 1.5 *
- ADS Promblaster II / Promwriter 4.0 * (w/ schematic)
- CompuPro CP/M 68K Technical Manual and Installation Procedures *
- Qty. 3 CompuPro RAM22 Technical Manual (w/ schematic) *
- CompuPro System Enclosure and Motherboards Technical Manual * (w/
stickers and schematics)
- Qty. 2 CompuPro DISK1 Technical Manual w/ schematics *
- Qty. 2 CompuPro System Support 1 User Manual * (w/ schematics)
- ViaSyn MDrive/H Technical Manual * (w/ schematics)
- CCT Brochures, Price Lists
- 4 issues of C-Pro newsletter, volume 2, issues 1-4, 1985 *
- Tarbell BASIC I/O System - cassette version, version 12.12 listing
- Tarbell Cassette BASIC, version 12.14 listing
- CompuPro System 816A Standard Switch Settings and Cable
Connections
- CompuPro CP/M-80 2.2 Technical Manual and Installation Procedures
- Digital Research CP/M-86 Release Notes, version 1.1 *
- CompuPro System Support 1 Technical Manual * (w/ schematics)
- CompuPro CPU-Z User Manual * (w/ schematics)
- Qty. 2 ViaSyn/CompuPro CPU 8085/88 Technical Manual * (w/
schematics)
- Qty. 2 CompuPro RAM17 Technical Manual * (w/ schematics)
- CompuPro DISK1A Technical Manual * (w/ schematics)
- CompuPro System 8/16 Enclosure and Motherboards Technical Manual *
(w/ schematics)
- CompuPro Concurrent DOS 8-16 Installation and Customization Guide
* (marked "Advance Copy")
- CCT Concurrent DOS 8-16 CMX XIOS User Guide *
- Macrotech MI-286 Dual Processor (80286/Z80H) Reference Manual *
(w/ schematics)
- Vector Electronic Interfacer II Technical Manual * (w/ schematics)
- CompuPro FORTH Technical Manual *
- Performics SRAM 128/258 User's Manual * (w/ schematics)
- CompuPro CPU-68K Technical Manual * (w/ schematics)
- CompuPro RAM16 Technical Manual * (w/schematics)
- CompuPro RAM21 Technical Manual * (w/ schematics)
- Franklin Electric I/O Serial Parallel Assembly and Test
Instructions *
- Data Technology Corp. DTC-10-1 Preliminary Specification (w/
schematics)
- CompuPro CP/M 80 2.2 Hard Disk Installation Guide *
- CompuPro MDrive Installation Manual *
- CompuPro CP/M 8-16 Technical Manual and Installation Procedures *
- CompuPro CP/M-86 Technical Manual and Installation Procedures *
- QumeTrak 842 8" Floppy Maintenance Manual
- Jade Double D Floppy Controller Manual * (w/ schematics)
- Qume DataTrack 8 Maintenance Manual
- Shugart 800/801 OEM Manual
- PSS Model MM8 8K RAM System Manual
- Solid State Music PB1 EPROM Programmer Board * (w/ schematcs)
- SD Systems ExpandoRAM Operations Manual * (w/ schematics)
- Tarbell Cassette Interface (w/ schematics)
- Mullen Computer Products TB4 * (w/ schematics) S-100 test/probe
board
- Jade Serial Parallel Interrupt Controller * (w/ schematics)
- Jade "The Big Z" (Z80 CPU board) * (w/ schematcs + monitor)
- CompuPro TMXBIOS listings *
- CompuPro DISK3 (ST506) Technical Manual * (w/ schematics)
- CompuPro AMCALL and MCALL-II (comm prog.) Operations Manual *
- CompuPro AMCALL and AMCALLN (supplement to above) *
- Qty. 2 CompuPro CP/M 2.2 Technical Manual and Installation
Procedures *
- Qty. 2 CompuPro CP/M-86 Technical Manual and Installation
Procedures *
- Soroc IQ120 terminal Specifications and Operating Procedures *
- Digital Research/CompuPro CP/M 2.2 User Reference Manual * (1 from
1982, 1 from 1978)
- Qty. 2 Digital Research CP/M-86 System Guide *
- Qty. 2 Digital Research CP/M-86 User's Guide *
- Qty. 2 Digital Research CP/M-86 Programmer's Guide *
- CompuPro Concurrent DOS 8-16 User's Guide *
- Digital Research Concurrent CP/M User's Guide *
- Digital Research Concurrent CP/M System Guide *
- Digital Research Concurrent CP/M Programmer's Reference Guide *
- Digital Research Concurrent CP/M-86 Programmer's Utilities Guide *
- Lattice C Compiler v2.15A For 8086/8088 *
- Digital Research DR Assembler Plus Tools for CP/M-86 *
- Digital Research C Language for CP/M-86 *
- Digital Research CBASIC Compiler for CP/M-68K *
- Digital Research CP/M-68K User/System/Programmer Guides *
- Digital Research C Compiler guide for CP/M-68K *
- Supersoft Version 1.2 C Compiler for CP/M-80 *
- DBase II User Manual
- DBase II Reference
- Microshell 1.2 User Manual
- CP/M 2.2 Patches and Application notes from Digital Research
- PC-Pro User's Guide
- Wordstar 3.0 Customization Notes
- Wordstar 3.0 General Information Manual
- Wordstar 3.0 Installation Manual
- Wordstar 3.0 Reference
- Supersort 1.6 Operator's Handbook and Programmer's Guide
- Datastar 1.1 User's Guide
- CBASIC Version 2 Language Manual
- The Zapple Monitor Version 1.1
- Word-Master 1.07 User Manual
- SpellGuard User Manual
- MAC -- Cal Poly Macro Assembler Manual *
- Tarbell BASIC Manual
- Calcstar 1.0 User's Manual
- BSTAM Version 4.6 User Manual
- CB-80 Languare Release Notes, and Reference Manual
- Cal Poly/Link-80/RMAC/Library User's Guide
- SID User's Guide
- Microsoft MBASIC Compiler User's Manual
- Microsoft BASIC-80 Reference Manual
- Microsoft Utility Software User Manual
(MACRO-80/LINK-80/CREF-80/LIB-80)
- Island Cybernetics Information Retreival System v2.07 User's
Manual
- CP/M 3.0 System/Programmer/User Guides
- CP/NET User's Guide
- MP/M-II System/User/Programmer Guide
Non-Original Disks (all 8", mixed 1S/2S, mixed densities)
- Concurrent DOS 3.1D
- Concurrent DOS 4.1D
- CompuPro CP/M 8-16 Implementation Files
- CompuPro CP/M 2.2N
- Godbout CP/M 8-16 1.1PD
- CompuPro CP/M 8-16 1.1R
- MP/M-II 2.1
- MP/M-II 8-16
- MP/M Gen
- BDS C 1.46
- Datastar
- Wordstar
- Spellguard
- Wizard C 2.1D
- Aztec C 3.2
- Lattice C 2.15
- DRI Assembler/Tools for CP/M-86
- 68K Cross-assembler
- CB80 1.3
- CBASIC 2.38
- Fortran 80
- Turbo Pascal for CP/M-86
- SuperSort
- DBase II
- Selector III
- Datastar 1.4
- IRS Infomaster
- BSTAM (telecomm program)
- BDS C 1.45
- Word-Master
- Random House Thesaurus
- Wordstar-86
- Small C 1.1
- Calcstar 1.2
- Microsoft BASIC v.4.5, 4.51, 5.1, 5.2
- CP/NET Version 1.0
Whew! That's all folks....
Rich B.
Received on Tue Dec 04 2001 - 07:32:57 GMT
This archive was generated by hypermail 2.3.0
: Fri Oct 10 2014 - 23:33:37 BST