Questions about TRS-80 Expansion Interface

From: Gene Buckle <geneb_at_deltasoft.com>
Date: Thu Jan 18 15:58:16 2001

Sellam, this might be an obvious question, but does the EI have the serial
port option board installed? There is a plastic cover that's held down by
two screws (I _think_) on the top of the EI that covers the little serial
board. If it _is_ installed and it hasn't been modified, it would be a
good idea to pull it and clean the connectors on both the serial board and
the EI since they're just a pressure fit with no real connector.

The edge connector is the serial port. There is also an edge connector
that brings out the parallel port lines. You can figure out which is
which by tracing the lines on the board. I'm pretty sure the serial
connector comes out the left side as you face the EI.

g.


On Thu, 18 Jan 2001, Vintage Computer Festival wrote:

>
> I need to know where the serial port connector is on a TRS-80 Expansion
> Interface. I have two of them. One has its ports labeled, and one of the
> ports is labeled "MODEM" but it is simply an edge connector. Is this the
> serial port? If so, what's the pinout?
>
> Any help would be greatly appreciated. Thanks!
>
> Sellam Ismail Vintage Computer Festival
> ------------------------------------------------------------------------------
> International Man of Intrigue and Danger http://www.vintage.org
>
>
Received on Thu Jan 18 2001 - 15:58:16 GMT

This archive was generated by hypermail 2.3.0 : Fri Oct 10 2014 - 23:33:47 BST