11/53 - DELQA question

From: Gooijen H <GOOI_at_oce.nl>
Date: Tue Jan 8 01:59:05 2002

   Thanks everybody for the clear replies.
I removed the bus expansion card (for the external box)
and when I powered up the system again, it just ran fine.

The next step I did was move the RQXD3 to the location
where that bus expansion card was and where the RQDX3
was I inserted a DELQA (M7516). I connected the bulkhead
cable and mounted a 10Base2 transceiver on the AUI connector.
The 10Base2 transceiver has the bare minimum network: just
the T-connector with on both sides 50 Ohms terminators.

The system still boots and runs fine, but I expected to
see the XE: (?) device listed with the $SHOW DEVICES command.
(The system runs Micro/RSX 3.1).
Current config:
slot 1 A/B-C/D : M7554-02 KDJ11, 15 MHz, 1.5 Mb
slot 2 A/B : M3106 4 line EIA MUX
slot 3 A/B : M7546 TQK50
slot 4 A/B : M7516 DELQA
       C/D : M7555 RQDX3
all other slots are empty.

Must the system with the new DELQA interface be sys/generated?
Am I doing something wrong?

TIA

- Henk.
Received on Tue Jan 08 2002 - 01:59:05 GMT