--- Gunther Schadow <gunther_at_aurora.regenstrief.org> wrote:
> Since we were chatting about RA80s has anyone of you had an RA8x on
> top of a short rack?
Never done that. I've never wanted to lift them that high. :-)
> I have put on up onto my HSC90 but I found that
> they don't actually slide into the rack but the top panel of the rack
> is removed and then you can open the hood of the RA8x without
> pulling out the "drawer". This is a perfect arrangement for an RA60.
The 42" cab for the RA60 was a little different than the standard, IIRC.
It had extended-length sides, and was set up to have the top of the
upper-most RA60 accessible without sliding it out. The extra length
is to accomodate the long drive and still provide room for SDI cables
at the rear (and perhaps a cable support arm, I forget if the RA60s
used them)
> However, I think there are some minor special parts that fill the
> gap between the side panels of the rack and the actual drive. Does
> anyone of you have those spare lying around somewhere or know where
> one might get those?
I have no spares and would have no idea where to get such things except
a scrapper who hadn't yet cut his racks into handfuls of metal chips.
-ethan
__________________________________________________
Do You Yahoo!?
Yahoo! - Official partner of 2002 FIFA World Cup
http://fifaworldcup.yahoo.com
Received on Tue Jun 04 2002 - 10:34:40 BST