Questions about Central Point Deluxe Option board

From: Fred Cisin <cisin_at_xenosoft.com>
Date: Wed Jun 26 19:27:17 2002

On 26 Jun 2002, Jeffrey H. Ingber wrote:
> That makes quite a bit of sense, and how I remember the cabling as
> well. I need to make a suitable cable to go from the drive controller
> to the option board it would seem. The issue is probably whether or not
> the cable has a twist - I would assume it would NOT, since the standard
> floppy cable would take care of that.

No twist.
Just straight 34 pin ribbon cable with a dual row header on one end and a
card edge connector on the other. You could take an old AT floppy cable,
and cut it off before the twist. That's a bit longer than you need, but
works fine.

> Looking at the stylized picture on the manual cover, it appears the OB
> is replacing the drive controller. Needless to say this doesn't mean
DOES NOT

> Would anyone happen to have a manual that could confirm our suspicians?
Don't need no stinkin' manual.
Received on Wed Jun 26 2002 - 19:27:17 BST