> Doug Carman wrote:
>Gunther Schadow wrote:
>
>> I guess so. I personally have a uVAX-II in the small cabinet, but
>> I take anything, I don't care about the larger metal pieces, what
>> I care about is the cable to the card and the SDI connectors.
Those
>> should be the same. I need the picture so a guy who doesn't know
>> these things but may have the cables in a pile of stuff can
recognize
>> it.
>
>I have the cable kit for the BA200 series cabinets as well. You
are
>right, it will work in a BA123 if you just route the pigtails out a
hole
>in the rear bulkhead. The part number for the one I have is
>17-00951-03. It has a 32 pin Berg connector on the module end with
a
>funny flat plastic retainer that holds it in. The pigtails are
about 30
>inches long and each has the metal 8 pin connector that mates to
the
>disk drive cables.
The KDA50 User Guide is at:
http://208.190.133.201/decimages/moremanuals.htm
The BA23 cab kit is pictured on p2-2.
It's basically a rectangular panel with two
connectors for SDI cables. The internal
cable just plugs in on the inside (and the
external cables - somehwhat thicker)
plugs in externally. You need two bulkheads
if you want to use all four possible
drives. The internal cable is four tails
connected to a single flat head with
a plastic cover at the KDA50 end. (It's not
*that* clear from the picture unless you
already know what you are looking at).
More pictures on pp 2-14, 2-15 and 2-16.
I cannot find a picture of the BA213 arrangement.
The KDA50 board pair sits behind a three-wide
metal panel (the third slot is occupied by the
cabling). The internal cable is the same and heads
up and to the top left drive bay. There is where
the bulkhead lives ... a recessed four-way
connector. I expect I'll find a picture
as soon as I hit "Send" ...
Antonio
Received on Tue Mar 12 2002 - 12:35:20 GMT