The adaptor fits on the 20-contact video edge connector near the middle of
the front panel. Just remove the shunt and replace it with the TTL-Composite
adaptor. The shunt just takes the signal from the contact on the bottom of
the O1's circuit board and carries it to the corresponding contact on the
top. So, if the converter does not also run the signals to the top of the O1
board, the internal monitor will not be on -- only the external composite
monitor will be.
-----Original Message-----
From: Glen Goodwin [mailto:acme_ent_at_bellsouth.net]
Sent: Thursday, May 30, 2002 12:03 AM
To: cctalk_at_classiccmp.org
Subject: Re: Osborne 1 Video Adapter? (was:RE: IBM 026 Printing Card
Punch)
> From: Feldman, Robert <Robert_Feldman_at_jdedwards.com>
> I was looking through the Alltronics listings and noticed a TTL-Composite
> video adaptor (http://www.alltronics.com/computer_miscellaneous.htm ,
> #92C024) that looks like the adaptor I have for my Osborne 1!
Robert --
Please tell me more about this adapter. I like my Oz 1 but hate the
screen. Where does it connect to the Oz?
Glen
0/0
Received on Thu May 30 2002 - 08:20:00 BST