Earlier today, I had Mintaka (Cromemco System Two) opened up and had
her cards pulled so I could write down an inventory of what all she
has in her. I noticed that on the FDC16 floppy controller, there is
a wire plugged into a 2 pin connector on the card. The other end of
the wire is not connected to anything. Any idea what it is supposed
to go to? Here is a picture of the wire and connector in question...
http://www.oz.net/~otter/Geekware/What-is-This-Connector-0.JPG
I also noticed that the TU-ART card has a similar 2 pin connector,
with nothing attached to it.
http://www.oz.net/~otter/Geekware/What-is-This-Connector-1.JPG
Is that where the other end of the wire is supposed to go? And if
so, what about that connector in the middle of the wire?
Thanks
-- Scarletdown
Received on Fri Oct 18 2002 - 00:36:01 BST
