Veroboard trace cutting tool?

From: Ethan Dicks <ethan.dicks_at_gmail.com>
Date: Sun Dec 5 04:57:12 2004

Does anyone know where I can locate a genuine tool for severing the
traces on veroboard? I know I can make do with a drill bit, but that
puts a tapered hole in the resin board underneath.

One thing that's cheaper in NZ is, strangely enough, veroboard. The
few pieces I found in the States were priced much higher than
protoboards used to be at Rat Shack (when you could find them). I
occasionally run into a project from a UK experimenter, and have
wanted to do their designs without doing 100% point-to-point. I'll
probably bring home a couple of panels so I have a chance to do that
(for my own stuff, I'll probably always do point-to-point).

-ethan
Received on Sun Dec 05 2004 - 04:57:12 GMT

This archive was generated by hypermail 2.3.0 : Fri Oct 10 2014 - 23:36:37 BST