Veroboard trace cutting tool?

Contemporary messages sorted: [ by date ] [ by thread ] [ by subject ] [ by author ] [ by messages with attachments ]

From: Bert Thomas <bert_at_brothom.nl>
Date: Sun Dec 5 06:31:30 2004

> However, if I want it to look neater (I meant to mention this in my
> previous message) -- though goodness knows who would care -- I have
> been known to use a scalpel or craft knife to cut the copper either
> side of a hole and then lift off the small redundant piece. I've also
> done that between holes, when I wanted to use two adjacent holes but
> isolated from each other.

Aaarggghhh, <undo><undo><undo><undo><undo>... ;-)
Received on Sun Dec 05 2004 - 06:31:30 GMT

This archive was generated by hypermail 2.3.0 : Fri Oct 10 2014 - 23:36:37 BST