I would definitely like SOME of the gear listed in that auction, but there's
no way I can swing a 40' truck to move all of it, or more importantly I
don't have ROOM for that much gear!
Jay West
----- Original Message -----
From: "Mark Davidson" <medavidson_at_mac.com>
To: "General Discussion: On-Topic Posts Only" <cctech_at_classiccmp.org>;
<arcarlini_at_iee.org>
Cc: "'General Discussion: On-Topic and Off-Topic Posts'"
<cctalk_at_classiccmp.org>
Sent: Monday, May 03, 2004 1:54 PM
Subject: VAX Cluster on Ebay in OK (was Re: More DEC equipment spotted
inKansas City)
> Someone's listed an entire VAX cluster with an 11/785 on EBay...
> http://cgi.ebay.com/ws/eBayISAPI.dll?
> ViewItem&item=4128752485&category=1247&sspagename=STRK%3AMEBWA%3AIT&rd=1
> and the opening bid is only $500. If I could figure out how to get it
> out to CA, I'd bid on it!
>
> On Apr 29, 2004, at 1:35 PM, Antonio Carlini wrote:
>
> >> Think roughly the equivalent of 2-3 19" racks, and that's just for
> >> the single enclosure holding the CPU. You'll need at least a 19"
> >> rack for the disk drives.
> >
> > A single VAX 6000 cab is (from memory) a bit wider than a 19" rack,
> > but not by more than maybe a hand each side. There was an official
> > cab kit that let you run a set of RA7x drives (maybe in an SA7x
> > enclosure) in the bottom of the VAX 6000 cab. There may
> > even have been an official way to run a brace of RA9x drives
> > in there too. So it would be possible to run a VAX 6000 in
> > a single cab.
> >
> > These days, assuming you are not going to be asking for
> > official support :-), you could try cramming an HSJ and
> > a string of SCSI drives in the bottom and stick a DSSI
> > card in the 6000 ...
> >
> > Antonio
> >
> >
> > --
> >
> > ---------------
> > Antonio Carlini arcarlini_at_iee.org
> >>
> >
>
>
---
[This E-mail scanned for viruses by Declude Virus]
Received on Mon May 03 2004 - 14:10:57 BST