Hi Guy,
perhaps I can be of some help here.
I've got the original Emulex documentation of the TC12 tape coupler,
and also the TC02 tape coupler. Both boards are quad-sized, the TC12 is
for UNIBUS, the TC02 is for QBUS systems.
To identify if your board is a TC12, I describe what is in manual.
(wished that those pictures were in more manuals, they're great!)
With the four rows of finger contacts right before you, in the middle
of the board, at the left of the center are two DIP switch packages,
and to the left of those are first 2 small IC's followed by 2 big AMD
2901 bit slices. At the opposite of the 4 finger contact rows (which
go into UNIBUS slot positions C,D,E,F) are two 50-pin BERG header
connectors.
If this manual seems to be what you are looking for I can scan it
at 600 dpi. Big file, but when printed gives very good copies!
The contents (briefly): Introduction - General Description - Functional
Description - Packet Processing - Installation - TC12 Option Switches -
Address Selection - Autoconfigure and VMS, RSTS/E and RSX-11M.
See mainecoon for an impression of the scan quality -- they are my work.
- Henk, PA8PDP.
-----Original Message-----
From: cctalk-bounces_at_classiccmp.org
To: General Discussion: On-Topic Posts Only
Cc: cctalk_at_classiccmp.org
Sent: 11-10-2004 6:07
Subject: Emulex TC12 controller
Hi,
I'm looking for information on the Emulex TC12 (I'm assuming) tape
unibus controller.
I have two Kennedy 9300 drives that I'd like to hook up and I have an
Emulex TC12. I also have an AVIV board (hex height with 2 50 pin
connectors on the top) that I have no other information on.
Any help would be appreciated.
Thanks.
--
TTFN - Guy
Received on Mon Oct 11 2004 - 13:45:11 BST