--- Philippe Vachon <phirkel_at_sympatico.ca> wrote:
> Hello (again!).
>
> I'm very pleased with my VAX 4000/300 thus far, but
> I'm about to get a
> KZQSA card from someone, and I need to move my TQK70
> controller over on
> the Q-bus so that the KZQSA card can fit into the
Make sure there is no gap between your Q-bus cards.
vax, 3900
> machine. However,
> when I did a test run of this, the card was
> responding (show dev showed
> the card), but it wouldn't find the TK70 tape drive
> attached to the
> TQK70. Is there a jumper I have to set? Or did I
> screw up in some other
> way?
>
> Thanks.
>
> Phil.
>
>
__________________________________
Do you Yahoo!?
Yahoo! Mail - 50x more storage than other providers!
http://promotions.yahoo.com/new_mail
Received on Wed Sep 08 2004 - 20:25:32 BST