Ok, sorry I can't help.
Then the graphics chip was the NEC7220.
- Henk.
> -----Original Message-----
> From: cctalk-bounces_at_classiccmp.org
> [mailto:cctalk-bounces_at_classiccmp.org]On Behalf Of Philip Pemberton
> Sent: dinsdag 11 januari 2005 11:49
> To: cctalk_at_classiccmp.org
> Subject: RE: uPD7210 datasheet
>
>
> In message <3C9C07E832765C4F92E96B06BDC0747A011134D0_at_gd-mail03.oce.nl>
> Gooijen H <GOOI_at_oce.nl> wrote:
>
> > it's been a long time, but I vagely remember the 7210 as
> the graphics
> > processor from NEC.
>
> Nope - the 7210 was NEC's IEEE-488/HPIB/GPIB controller chip.
> I've got a CEC
> PCI-488 GPIB card that uses it and the "Advanced Programming"
> section of the
> manual makes a lot of references to the 7210 datasheet...
>
> What I want to do is make the CEC card act like a GPIB device
> that's been set
> to "Always Listen" mode so I can take copies of the screen on
> my HP 1651B
> logic analyser. It shouldn't be too hard to write a bit of
> code to convert
> the Laserjet control codes into a bitmap image...
>
> Later.
> --
> Phil. | Acorn Risc PC600 Mk3,
> SA202, 64MB, 6GB,
> philpem_at_philpem.me.uk | ViewFinder, 10BaseT
> Ethernet, 2-slice,
> http://www.philpem.me.uk/ | 48xCD, ARCINv6c IDE, SCSI
> ... Eagles Soar!, but weasels aren't sucked into jets!
>
Received on Tue Jan 11 2005 - 04:52:58 GMT