Allison J Parent wrote:
> < In the workshops I've seen where it's handled, it's usually done with a
> < very sharp tool with a very acute cutting angle (I've seen razor blades
> < mounted in a holder for this) and lubricated with glycerine.
>
> You can if you have the right tools. Grinding is easier for most to do.
> I make TU58 drive wheels using thickwall rubber tube or tygon and mount
> the assembled result on an old tu58 motor and "grind" on a bench grinder.
> I get a good round smooth surface, minimal setup. The hub used is the
> one with the tire turned to goo, with the goo removed.
I say it depends on what you have to do. I've reworked wheels and tires for
obsolete reel to reel (audio) decks and vcr's by drilling a hole, gluing in
the old shaft, and then trimming down the block to close shape of a circle
with a pocket knife. I then chuck the shaft in a drill that's fixed to a
bench and then use a file at first and then an emery board to smooth it.
Whatever works - that's the solution.
--------------------------------------------------------------------
Russ Blakeman
RB Custom Services / Rt. 1 Box 62E / Harned, KY USA 40144
Phone: (502) 756-1749 Data/Fax:(502) 756-6991
Email: rhblake_at_bbtel.com or rhblake_at_bigfoot.com
Website:
http://members.tripod.com/~RHBLAKE/
ICQ UIN #1714857
AOL Instant Messenger "RHBLAKEMAN"
* Parts/Service/Upgrades and more for MOST Computers*
--------------------------------------------------------------------
Received on Mon Aug 03 1998 - 14:29:31 BST