Tony Duell wrote:
>
> >
> > Recently I bought 2 IBM 5170's (PC/AT) for 6 bucks. I bought these
> > machines to add to my collection. Both of them say this when I boot up:
> > "162 - System Options Not Set - (Run SETUP)"
>
> That normally means that something has changed since the CMOS RAM was
> configured.
>
> > Both of them have a 512k System board. One only shows 256K of memory
> > during memory test and the other one shows 512K but has a parity error.
>
> Which version of the system board do you have? The older one has 36 RAM
> chips, each one being a 128K*1 device (actually made from 2 DIPs soldered
> together). The later one has 18 256K*1 bit devices on it. I have
> schematics, etc for both boards.
>
> The partiy error sounds like a RAM chip failing. Try reseating them, and
> if it's the later version, try replacing the RAMs one at a time with
> known-good ones. 256K*1 DRAMs are pretty easy to get, and the ones on the
> system board are socketed.
>
> > Is there any dip switches on the motherboard, and is SETUP a software
>
> There are 2 switch-things on the system board (unless you count the
> little 8-pin DIP postion behind the expansion slots that can be used to
> fiddle with the ROM addressing).
>
> One is a slide switch next to the power connector. In one position the
> board is set up for an MDA display. The other way for a CGA one. I can't
> remember which is which, but if you get it wrong, all that happens is
> that it fails the POST and beeps. Flip the switch and try again.
>
> The other is a jumper (J18) to the left of the speaker connector at the
> front). This selects between 256K and 512K for RAM on the system board.
> Check this is set the same way on both your boards.
>
> > program?
>
> Yes, SETUP is the program used to load the parameters into the CMOS RAM.
> Unlike most modern PCs, this is not in ROM, but has to be loaded from
> disk. There's a free clone (with source, I think) on Simtel somewhere. If
> the parameters have got scrambled, then about the only thing it can boot
> from is a 5.25" drive as A:
>
> -tony
Thanks for the very helpful information Tony. I would like a copy of
the shematic if you can swing it!
--Alan
--
Computing since: 1982, VIC-20, CoCo, PC, CP/M
Amateur Radio since: 1971, WN8JEF, KA6EXR, N8BGR, AA4ZI
BASIC, dBASE, Assembly, C++
<A
HREF="http://www.bright.net/~oajones">http://www.bright.net/~oajones</A>
Received on Sat Sep 19 1998 - 20:24:14 BST