> There should be
>some plastic catches (or more likely the remains of same) on the PSU.
I've found that most half-inch tape seals have latches which are
quite amenable to being used as replacements for the original plastic
catches :-).
>BTW, one of the few pieces of poor design in this machine is that you
>have to take the left side rackmount rail off the box before you can get
>the PSU out. This means you have to take the entire (heavy) machine out
>the rack before you can remove the PSU.
If you use short 10-32x1/4" screws on the left rail, it's a lot easier to
take the PSU out. (I thought everyone shortened these screws!)
With the original screws (3/4"), it is possible to get the PSU in and out
with the rail attached, but it is quite difficult and requires that the
PSU be inserted at a rather awkward angle.
--
Tim Shoppa Email: shoppa_at_trailing-edge.com
Trailing Edge Technology WWW: http://www.trailing-edge.com/
7328 Bradley Blvd Voice: 301-767-5917
Bethesda, MD, USA 20817 Fax: 301-767-5927
Received on Fri Apr 09 1999 - 21:45:28 BST