Gold price was: Re: ebay feedback

From: Joe <rigdonj_at_intellistar.net>
Date: Tue Dec 7 11:26:16 1999

You can safely let the air in (or vacuum out) of a CRT by breaking the
"tit" on the back end of the CRT where the air was evacuated. It may be
covered by the plug for the electrical connections. If it is then just
break the plug off. The glass is very thin there and I've seen may people
just use a karate chop motion with almost any metal object to break the end
of the tit off. That will let the air in and the rest of the tube stays
intact.

   Joe

At 12:05 PM 12/7/99 +0000, you wrote:
>In article <m11v9t8-000IyJC_at_p850ug1>, Tony Duell
><ard_at_p850ug1.demon.co.uk> writes
>>c) Place the CRT outside, put a couple of old coats over it and throw a
>>hammer at it (!).
>>
>>I am NOT RESPONSIBLE for any injury caused by trying the above, BTW!!!
>>Modern CRTs can't violently implode, but it's still wise to take care.
>
>I have included the caveat in the quote for obvious reasons. A master
>at my old school used to break up old CRTs by _gently_ tapping at the
>base of the neck with the ball of a hammer. This created a small hole
>to release the vacuum.
>
>It looked dangerous to me so I used the 'blanket and brick' approach as
>in (c) above or put the tube in a dustbin and crouched down beside the
>bin and used a hammer to knock off the neck keeping the bin between me
>and the CRT.
>--
>Regards
>Pete
>
Received on Tue Dec 07 1999 - 11:26:16 GMT