> Ok, so my DECServer has to boot its image rather than run it from flash.
> Not a problem, however when the system reboots it loses all of its
> configuration information as far as I can tell. Is this normal? Is there no
> NVRAM inside or perhaps I've got a dead battery somewhere? Alternatively,
> is there some way to "upload" the configured image such that I could boot
> _that_ and thus be preconfigured?
The configuration information should be saved. Are you using change,
define, or set? If you you set, only the volatile configuration is
changed. define changes only the permanent configuration, and change
changes both.
--
Eric Dittman
dittman_at_dittman.net
Received on Fri Aug 03 2001 - 12:02:30 BST