Wiring Classic Machines to Triacs (was: Assembly vs....

From: Richard Erlacher <edick_at_idcomm.com>
Date: Wed Aug 22 00:11:14 2001

see below, plz.

Dick

----- Original Message -----
From: "Don Maslin" <donm_at_cts.com>
To: <classiccmp_at_classiccmp.org>
Sent: Tuesday, August 21, 2001 10:22 PM
Subject: Re: Wiring Classic Machines to Triacs (was: Assembly vs....


>
<snip>
> **** www.gatewayelex.com ****
>

Sadly, this web site is for the St.Louis store only, though it mentions the
other stores. It reflects very little of what's at the Denver Gateway store,
though some of the Denver stuff comes from St.Louis, which was the first store.
There's quite a lot of electronics manufacturing in the Denver-Boulder-Longmont
area, not to mention Ft.Collins and Colorado Springs, and the Denver store buys
everywhere it can. I've tried to encourage the guys to set up a site at their
store, but the St.Louis based mgmt is against it.

One of the owners/founders passed on recently and that may signal some impending
changes in operating style and pace, but I wouldn't bet on it.

>
> > > Web references, book references, personal experience, *any* info is
welcome!
> > There are LOTS of sites that handle "controlling the world" interface
issues,
> > and may show up on GOOGLE searches using simply the most obvious search
terms.
> > Try "stepping motor" or Fourier Series, just for grins ...
> > >
> > > Thanks loads (and trying to keep the S/N ratio higher...)
> > >
> > > Roger "Merch" Merchberger
> > > --
> > > Roger "Merch" Merchberger --- sysadmin, Iceberg Computers
> > > Recycling is good, right??? Ok, so I'll recycle an old .sig.
> > >
> > > If at first you don't succeed, nuclear warhead
> > > disarmament should *not* be your first career choice.
> > >
> > >
> >
> >
>
>
Received on Wed Aug 22 2001 - 00:11:14 BST