CD-ROM on RT-11?

From: Jerome H. Fine <jhfinepw4z_at_compsys.to>
Date: Thu Apr 4 18:17:02 2002

>"Zane H. Healy" wrote:

> > I think what I'll do at this point is try to make an image with
> >exchange of v5.03 with my program and all, and copy as well as copy/boot
> >it to a scsi disk on the vax, and then move it to the PDP. Assuming I get
> >far enough to get that working, I'd then experiment with getting it on the
> >CD. I did end up coming across a Viking/QDT SCSI controller, but it
> >doesn't have bootstrap, and I don't have a BDV11, nor do I have room for
> >one. I may buy a CQD-200, as they are a lot cheaper than the the CQD-220.
> >I'd be willing to trade the Viking if anyone wants to swap.
> While not as fast as the CMD controllers the Viking/QDT is a good solid
> controller. What version are the ROMs on it? You need a fairly new
> version to support CD-ROMs. This is the controller that I use on my
> PDP-11/73 (in fact I just booted off of CD-ROM this morning). I know for a
> fact that it will talk to a DEC RRD-42 CD-ROM (which I like since it's a
> caddy drive).

Jerome Fine replies:

I presume from what you are saying that the Viking/QDT does not have any
boot ROMs. If so, it is one of the very few (probably the only one I know
about) NON-DEC controllers or host adapters that does not have a boot
ROM.

Any idea if there was a DEC approved CDROM drive which did NOT
use a caddy?

> Before I got the Quad-Hieght /73, which has onboard bootstrap and console
> port) I had a dual-height /73 without the onboard bootstrap. At that point
> I had a WQESD ESDI controller in the system whose only purpose was booting
> the system and a DLV11J for the console port. I've still got the DLV11J in
> there as well as a RQDX3 in the system that's only there to drive the RX50
> floppies.

Any idea how much an M8190-BB (quad 11/73) might cost? I have a
couple, but I want to keep them for a few more years. But Tom might
find this is the least expensive way to go.

Sincerely yours,

Jerome Fine
--
If you attempted to send a reply and the original e-mail
address has been discontinued due a high volume of junk
e-mail, then the semi-permanent e-mail address can be
obtained by replacing the four characters preceding the
'at' with the four digits of the current year.
Received on Thu Apr 04 2002 - 18:17:02 BST

This archive was generated by hypermail 2.3.0 : Fri Oct 10 2014 - 23:34:29 BST