Need help with monitor in Japan

From: Dwight K. Elvey <dwight.elvey_at_amd.com>
Date: Wed Jul 14 14:36:52 2004

Hi
 A 12v filament transformer can be used to
boost the voltage. Also, Japan is 50Hz so
that may also be an issue.
 One could even use an AC wall wart as long
as the output current was rated as high as that
used by the monitor. You just need to experiment
with the lead polarity to get the phase to boost.
You'd need to put this all in a closed box for safety
because the output wires of a wall wart are not
usually rated for 115V.
Dwight


>From: "Brent Hilpert" <hilpert_at_cs.ubc.ca>
>
>"Phab E. Oh" wrote:
>> I'm in Japan and having a problem with a US monitor.
>> It won't turn on...no power light or power up noises
>> or anything.
>>
>> So I measured voltage across neutral and ground and
>> there was 8VAC. So I got an electrician to wire up a
>> proper ground. There's still 1VAC across Neutral and
>> Ground.
>>
>> So I have two theories:
>>
>> 1) The monitor is seeing the floating ground and not
>> liking it and refusing to turn on.
>> 2) The monitor requires at least 110V (I'm getting
>> 103V).
>>
>> I'd hate to think this thing just died, so can anyone
>> confirm that a ground to neutral measurement should
>> yield 0V or some very negligible voltage?
>>
>
>If you are measuring between GND and neutral, a few volts measured is not
surprising (especially with a DMM with a high input impedance), resulting from
inductive/capacitive coupling between wires over the distance between your
measurement point and where GND and neutral are bonded in the building (assuming
that Japan does a straight GND/neutral bond as is done in North America).
>
>The 103V supply voltage is far more suspicious, as it is quite low relative to
115V (you don't say how old the monitor is, could it be that it predates power
supplies with 'universal' supply voltage range?). Try finding a power adapter
transformer to boost the voltage. (Normal Japanese line voltage is lower than
North America isn't it?). Or if you are around electronics people, try to find a
variac, as variacs typically have some boost on the upper end of their range
(for example, a variac fed with 120V will typically boost to at least 130V,
keeping in mind if the variac scale is presented in volts, the scale accuracy
will vary with the input voltage). (Or, being very careful not to go to the low
end, wire up the variac in reverse).
>
>Or (if the monitor is older) there's always looking inside the monitor for
jumpers, or alternative primary taps on a power transformer, to select input
voltages.
>
Received on Wed Jul 14 2004 - 14:36:52 BST

This archive was generated by hypermail 2.3.0 : Fri Oct 10 2014 - 23:36:51 BST