On Monday 27 September 2004 13:19, Ed Kelleher wrote:
> I have an Emulex UC08 SCSI <-> QBus board I'm trying to make work.
> It actually has 2 controllers on the board.
> I can get into the firmware on both controllers fine -- when no
> drives are connected.
> However, when I connect a SCSI drive to a controller,
> I can not get into the firmware for that controller.
<snip>
> Any ideas?
I'm not sure if it's a possible problem, but is the SCSI bus properly
terminated - at both ends?
Pat
--
Purdue University ITAP/RCS --- http://www.itap.purdue.edu/rcs/
The Computer Refuge --- http://computer-refuge.org
Received on Mon Sep 27 2004 - 13:56:57 BST