[OT]Homebrew PCB fabrication

From: Jim Brain <brain_at_jbrain.com>
Date: Sun Feb 20 22:17:37 2005

der Mouse wrote:

>>>Everybody I've looked into handwaves the issue, naming a couple of
>>>formats ("gerber" comes to mind) without any references, apparently
>>>assuming everyone will be using some kind of pre-rolled software to
>>>generate said files. Feh.
>>Eagle CAD makes it easy,
>I'm sure it does.
>However, assuming you mean the stuff from the cadsoftusa.com people,
>it's binary-only and hence a complete non-starter for me. That's why I
>was looking for file format doc, so I could roll my own as needed.
I don't understand why EAGLE is a non-starter, but you're OK with
AutoTRAX, also a binary, and DOS to boot.


Jim Brain, Brain Innovations
brain_at_jbrain.com                                http://www.jbrain.com
Dabbling in WWW, Embedded Systems, Old CBM computers, and Good Times!
Received on Sun Feb 20 2005 - 22:17:37 GMT

This archive was generated by hypermail 2.3.0 : Fri Oct 10 2014 - 23:37:39 BST