Hi,
OK, so the MicroVAX is *still* not responding... I've at least ruled the
power supply and the terminal and the terminal cables out however. I put the
power supply from the functional VAXstation 3100 in the MicroVAX, hooked up
the Wyse 50 I use with the VAXstation along with its DECConnect cable to the
MicroVAX (BTW; I used the MicroVAX's manual to set up the VAXstation,
therefore the cable must be plugged in properly), and turned the critter
on... same results as before.. The console says "_~" and that is about it..
The manual talked about that possibly indicating a disk drive problem, but I
tried it both with and without hard disk.. no dice. Any further ideas? Also,
I'm going to be finally updating my website with *far* more
Interdata/Perkin-Elmer/Concurrent info than anyone could possibly want,
along with the same scope of Nova 1210 info, including the sheet on how to
modify an ASR-33 with the DGC teletype interface board.
Will J
______________________________________________________
Get Your Private, Free Email at
http://www.hotmail.com
Received on Fri Dec 17 1999 - 23:50:27 GMT