On Sun, 19 Jan 2003, J.C.Wren wrote:
> Since this is a single sided board, as far as components go, the
I assume you mean single layer?
> bottom side would be easy. Scan it. The top side would be harder, but
> given that the majority of the parts are .3" wide, with the schematic, a
> lot of the routing can be inferred. And while I haven't looked closely
> at an Apple I board, the trace widths should be pretty wide, by todays
> standards. So by doing an overlay, and perhaps using some bright lights
> for manual verification, it seems that very near replica could be made.
Check out these photos:
http://vintage.org/special/apple-1/apple-1-front.jpg
http://vintage.org/special/apple-1/apple-1-rear.jpg
Received on Sun Jan 19 2003 - 08:07:00 GMT
