[OT]Homebrew PCB fabrication

From: woodelf <bfranchuk_at_jetnet.ab.ca>
Date: Sun Feb 20 18:13:07 2005

emanuel stiebler wrote:

> Just in case it is obvious, but did you check the prices for 2 layer
> boards ? I think the prices are as low as never before, so I wouldn't
> even start to do it on my own.

The prices may be low but what about good cad software?
Free or under $100 US would be nice.
Here in Canada I was looking at about $75? setup and $1.00 can per sq inch.
Of course two boards minum. Unless you plan to do 3x4 inch pcb's or
thousands
I too think getting the pros to do it is a better idea.
Ben alias woodelf.
PS the homebrew computer using CPLD's is going to need a far bigger
board than demo PCB software gives.
Received on Sun Feb 20 2005 - 18:13:07 GMT